J1

RTM Polyimide

J1 is a high-temperature thermosetting polyimide resin with service capability up to 371°C. Its low powder melt viscosity (300-600 cP at 274°C) makes J1 one of a small number of polyimides suitable for use in resin transfer molding (RTM) processes.

J1 does not contain the toxic diamine 4,4’-methylenedianiline (MDA) or any other mutagenic or carcinogenic components. Although it is most suited for RTM processing, its chemistry also allows for the use of autoclave processing or compression molding.

J1 is available as a PMR-type resin solution or as a pre-imidized powder from Maverick Corporation.

Download Product Data Sheet

Resin Properties

Resin PropertiesTest ParametersUnitsTypical Values
Solution Solids Content 204°C/180 min cure % 60 - 65
Solution Density (Room Temp.) - g/mL 1.10 - 1.15
Solution Viscosity (Room Temp) Brookfield spindle #RV-4, 100 rpm cP 100 - 500
Powder Melt Viscosity 274°C, Brookfield spindle #27, 50 rpm cP 300 - 600
Powder Volatile Content TGA ramp to 399°C % 4 - 6

Disclaimer: The data listed herein fall within the normal range of properties but should not be used to establish specification limits or used alone as the basis of design. Maverick Corporation assumes no obligations or liabilities for any advice furnished or for any results obtained with respect to this information. All such advice is given and accepted at buyer’s risk.

Back To Top

Section Links

Contact Us





I wish to receive updates from
Maverick Corp.